Opel Astra, Zafira

since 1998 of release

Repair and car operation



Opel Astra
+ Opel Astra and Zafira Cars
+ Operation manual
+ Routine maintenance
+ Engine
+ Systems of cooling, heating
+ Power supply system and release
+ engine Electric equipment
+ Manual transmission
+ Automatic transmission
+ Coupling and power shafts
+ Brake system
- Suspension bracket and steering
   Specifications
   Removal and installation of a rotary fist
   Check of a condition and replacement of stupichny assembly
   Removal and installation of a forward stretcher
   Removal, regenerative repair and installation of a rack of a forward suspension bracket
   Removal and installation of the forward stabilizer of cross-section stability
   Removal, regenerative repair and installation of the bottom lever of a forward suspension bracket
   Replacement of the bottom spherical support
   Removal and installation of back stupichny assembly
   Check of a condition and replacement of bearings of back wheels
   Removal, check of a condition and installation of the back shock-absorber
   Removal and installation of screw springs of a back suspension bracket
   Removal and installation of a torsionny beam of a back suspension bracket
   Replacement of rezinometallichesky hinges of longitudinal levers of a torsionny beam
   System of adjustment of a road gleam of a back axis - the general information and adjustment
   Removal and installation of the air valve and highway of a regulator of a road gleam of a back axis (Versatile person model)
   Removal and installation of a steering wheel
   Removal and installation of a steering column
   Removal, check of a condition and installation of an intermediate shaft of a steering column
   Replacement of protective covers of a case of the steering mechanism
   Removal and installation of the steering mechanism
   Removal and installation of the steering pump
   Air removal from a hydraulic path of GUR
   Removal and installation of tips of steering drafts
   Removal and installation of steering draft
   Corners of installation of wheels
+ Body
+ Onboard electric equipment


buy cialis online


Removal, check of a condition and installation of the back shock-absorber

For the purpose of saving of characteristics of stability and controllability of the car replacement of back shock-absorbers should be made in pairs.

Removal

 PERFORMANCE ORDER

  1. Prop up forward wheels protivootkatny boots, поддомкратьте a back of the car and establish it on props. Remove back wheels.
  2. On the Versatile person models equipped with system of adjustment of a back road gleam uncover the right back combined lamp in a luggage compartment and via the valve pit pressure from system. Disconnect from the shock-absorber an air tube.
  3. Prop up the corresponding longitudinal lever of a back beam a telezhechny jack.
  1. Turn out the bottom bolt of fastening of the shock-absorber to the lever.
  2. Holding the shock-absorber, turn out the top fixing bolt. Liberate the shock-absorber from the top basic arm.

Check

 PERFORMANCE ORDER

  1. Clamp the bottom basic arm of the shock-absorber in a vice with soft sponges and several times rock a rod from an emphasis against the stop. Any violations of smoothness of a course of a rod indicate need of replacement of both shock-absorbers.
  1. Estimate degree of wear of rezinometallichesky plugs of the shock-absorber, in case of need make replacement of both shock-absorbers.

Installation

Installation is made as it should be, the return to an order of dismantle of components.

 PERFORMANCE ORDER

  1. Track, that all fixture was tightened with demanded effort. On the models equipped with system of adjustment of a back road gleam, charge system superfluous pressure 0.8 bar, then if it is necessary, adjust pressure according to extent of loading of the car.