Opel Astra, Zafira

since 1998 of release

Repair and car operation



Opel Astra
+ Opel Astra and Zafira Cars
+ Operation manual
+ Routine maintenance
+ Engine
+ Systems of cooling, heating
+ Power supply system and release
+ engine Electric equipment
+ Manual transmission
+ Automatic transmission
+ Coupling and power shafts
+ Brake system
- Suspension bracket and steering
   Specifications
   Removal and installation of a rotary fist
   Check of a condition and replacement of stupichny assembly
   Removal and installation of a forward stretcher
   Removal, regenerative repair and installation of a rack of a forward suspension bracket
   Removal and installation of the forward stabilizer of cross-section stability
   Removal, regenerative repair and installation of the bottom lever of a forward suspension bracket
   Replacement of the bottom spherical support
   Removal and installation of back stupichny assembly
   Check of a condition and replacement of bearings of back wheels
   Removal, check of a condition and installation of the back shock-absorber
   Removal and installation of screw springs of a back suspension bracket
   Removal and installation of a torsionny beam of a back suspension bracket
   Replacement of rezinometallichesky hinges of longitudinal levers of a torsionny beam
   System of adjustment of a road gleam of a back axis - the general information and adjustment
   Removal and installation of the air valve and highway of a regulator of a road gleam of a back axis (Versatile person model)
   Removal and installation of a steering wheel
   Removal and installation of a steering column
   Removal, check of a condition and installation of an intermediate shaft of a steering column
   Replacement of protective covers of a case of the steering mechanism
   Removal and installation of the steering mechanism
   Removal and installation of the steering pump
   Air removal from a hydraulic path of GUR
   Removal and installation of tips of steering drafts
   Removal and installation of steering draft
   Corners of installation of wheels
+ Body
+ Onboard electric equipment

http://flashlottos24.ru/


Removal and installation of screw springs of a back suspension bracket

In view of design features of a suspension bracket back springs can be replaced only serially. Replacement of springs should be made in a set.

Removal

 PERFORMANCE ORDER

  1. Prop up forward wheels protivootkatny boots, поддомкратьте a back of the car and establish it on props. Remove back wheels.
  2. On the Versatile person models equipped with system of adjustment of a back road gleam uncover the right back combined lamp in a luggage compartment and via the valve pit pressure from system. Disconnect from the shock-absorber an air tube.
  3. Prop up the corresponding longitudinal lever of a back beam a telezhechny jack.
  1. Turn out the bottom bolt of fastening of the shock-absorber to the lever.
  1. Accurately wring out the longitudinal lever as far as possible down, without loading the brake line.
  2. Remove a spring and its rubber saddles from the longitudinal lever and a body element and take components from under the car (see an illustration the Design of a back suspension bracket), - pay attention that the top saddle is equipped with the built-in chipper.

Installation

Installation is made as it should be, the return to an order of dismantle of components. Pay attention to the next moments.

 PERFORMANCE ORDER

  1. Before installation of the shock-absorber make sure of correctness of installation of a spring and pro-rates.
  2. Track, that the fixture of the shock-absorber was tightened with demanded effort.
  3. Do not forget that springs should change in pair, - repeat procedure for the second spring.
  4. On the models equipped with system of adjustment of a back road gleam charge system air pressure 0.8 bar, then adjust pressure according to extent of loading of the car.