Opel Astra, Zafira

since 1998 of release

Repair and car operation



Opel Astra
+ Opel Astra and Zafira Cars
+ Operation manual
+ Routine maintenance
+ Engine
+ Systems of cooling, heating
+ Power supply system and release
+ engine Electric equipment
+ Manual transmission
+ Automatic transmission
+ Coupling and power shafts
+ Brake system
- Suspension bracket and steering
   Specifications
   Removal and installation of a rotary fist
   Check of a condition and replacement of stupichny assembly
   Removal and installation of a forward stretcher
   Removal, regenerative repair and installation of a rack of a forward suspension bracket
   Removal and installation of the forward stabilizer of cross-section stability
   Removal, regenerative repair and installation of the bottom lever of a forward suspension bracket
   Replacement of the bottom spherical support
   Removal and installation of back stupichny assembly
   Check of a condition and replacement of bearings of back wheels
   Removal, check of a condition and installation of the back shock-absorber
   Removal and installation of screw springs of a back suspension bracket
   Removal and installation of a torsionny beam of a back suspension bracket
   Replacement of rezinometallichesky hinges of longitudinal levers of a torsionny beam
   System of adjustment of a road gleam of a back axis - the general information and adjustment
   Removal and installation of the air valve and highway of a regulator of a road gleam of a back axis (Versatile person model)
   Removal and installation of a steering wheel
   Removal and installation of a steering column
   Removal, check of a condition and installation of an intermediate shaft of a steering column
   Replacement of protective covers of a case of the steering mechanism
   Removal and installation of the steering mechanism
   Removal and installation of the steering pump
   Air removal from a hydraulic path of GUR
   Removal and installation of tips of steering drafts
   Removal and installation of steering draft
   Corners of installation of wheels
+ Body
+ Onboard electric equipment




Replacement of rezinometallichesky hinges of longitudinal levers of a torsionny beam

Replacement of rezinometallichesky hinges should be made in pairs.

Removal

 PERFORMANCE ORDER

  1. Remove a torsionny beam (see. Removal and installation of a torsionny beam of a back suspension bracket).
  2. Before removal of hinges by a chisel beat out pro-rates from internal surfaces of levers.
  3. It is best of all to make dismantle of rezinometallichesky hinges by means of the special Opel tool though it is possible to use a long bolt with a nut, a washer and a piece of a pipe or a replaceable face head of suitable diameter not less effectively. Try to remember adjusting positions of hinges, before выпрессовывать them from levers.

Installation

 PERFORMANCE ORDER

  1. Grease new hinges with silicone greasing or soap water and press them in levers.
  2. Establish into place a beam (see. Removal and installation of a torsionny beam of a back suspension bracket).