Opel Astra, Zafira

since 1998 of release

Repair and car operation



Opel Astra
+ Opel Astra and Zafira Cars
+ Operation manual
+ Routine maintenance
- Engine
   Specifications
   Check of kompressionny pressure in cylinders
   Diagnostics of a condition of the engine with use of the vacuum gage
   + Procedures of repair of petrol SOHC engines without their extraction from the car
   - Procedures of repair of petrol DOHC engines without their extraction from the car
      Reduction of the piston of the first cylinder in the provision of the top dead point of a step of compression (VMT)
      Removal and installation of a cover of the gas-distributing mechanism
      Removal and installation of a pulley of a cranked shaft
      Removal and installation of a cover of a drive of GRM
      Removal and installation of a belt of a drive of GRM
      Removal and installation of cogwheels cranked / camshafts and intermediate rollers
      Replacement of epiploons of camshafts
      Removal and installation of camshafts and pushers of valves, check of a condition of components
      Removal and installation of a head of cylinders
      Removal and installation of the pallet of a case
      Removal and installation of the sensor of level of impellent oil
      Removal, service and installation of the oil pump
      Removal, check of a condition and flywheel installation / driving disk
      Replacement of epiploons of a cranked shaft
      Check of a condition and replacement of support of a suspension bracket of the power unit
      Removal, installation and adjustment of the balancing mechanism of a cranked shaft (engines of 2.0 l)
   + Procedures of repair of diesel engines of 1.7 l and 2.0 l without their extraction from the car
   + General and major maintenance of the engine
+ Systems of cooling, heating
+ Power supply system and release
+ engine Electric equipment
+ Manual transmission
+ Automatic transmission
+ Coupling and power shafts
+ Brake system
+ Suspension bracket and steering
+ Body
+ Onboard electric equipment

http://flashlottos24.ru/


Removal and installation of a pulley of a cranked shaft

L engines 1.4, 1.6 and 1.8

See. Removal and installation of a pulley of a cranked shaft.

Engines of 2.0 l

Removal

 PERFORMANCE ORDER

  1. Cock the parking brake, поддомкратьте a front of the car and establish it on props. Remove the right forward wheel and (at the corresponding complete set) protection of a case.
  2. Remove belts of a drive of auxiliary units (see. Head Routine maintenance) — previously put on a belt tape marking of the direction of its rotation.
  1. Turning a cranked shaft for a pulley bolt, achieve combination of its adjusting label with the index.
  1. Weaken and turn out small bolts of fastening of a pulley to a cogwheel of a cranked shaft and remove a pulley from the engine — in case of need hold a shaft from a provorachivaniye for a bolt of fastening of a cogwheel.

Installation

 PERFORMANCE ORDER

  1. Make sure of correctness of combination of a label of a cogwheel with the index on the case of the oil pump. Accurately establish a pulley of a cranked shaft on a cogwheel, screw fixing bolts and tighten them with demanded effort.
  1. Establish belts of a drive of auxiliary units (see. Head Routine maintenance) — track observance of the initial direction of rotation (see the marking put at removal).
  2. Establish protection of a case (tighten fixture with demanded effort).
  3. Lower the car on the earth, then tighten wheel fastenings with demanded effort.