Opel Astra, Zafira

since 1998 of release

Repair and car operation



Opel Astra
+ Opel Astra and Zafira Cars
+ Operation manual
+ Routine maintenance
+ Engine
- Systems of cooling, heating
   Specifications
   Antifreeze - general information
   + System of cooling of the engine
   - Systems of ventilation, salon and air conditioning heating
      Removal and installation of deflectors of air lines
      Removal and installation of resistive assembly of the driving electromotor of the fan of a heater
      Removal and installation of the driving electromotor of the fan of a heater
      Removal and control panel installation by functioning of systems of heating / ventilation / air conditioning
      Removal and installation of the main case of a heater
      Removal and installation of the heat exchanger of a heater
      Removal and installation of the switch of a heater
      Check of serviceability of functioning and service of systems of heating and air conditioning
      Removal and installation of the compressor of central air of air
      Removal and installation of the evaporator of central air of air
      Removal and installation of the condenser of central air of air
      Removal and installation of a receiver dehumidifier of central air of air
      Removal and installation of the additional fan
+ Power supply system and release
+ engine Electric equipment
+ Manual transmission
+ Automatic transmission
+ Coupling and power shafts
+ Brake system
+ Suspension bracket and steering
+ Body
+ Onboard electric equipment




Removal and installation of the evaporator of central air of air

Air central air constantly is under a high pressure. At all do not disconnect refrigerator lines and do not remove any components of system, previously without having executed a discharge of the last. The discharge of central air of air should be made by strengths of the skilled expert in the conditions of a car-care center workshop. At a rassoyedineniye of refrigerator lines surely put on goggles!


At replacement of components of central air of air the certain amount of replaceable refrigerator oil necessary for filling of volume of new knot is required. Use only the oil good for the use in R-134a systems (attentively study a label on the container).

Removal

Astra models

 PERFORMANCE ORDER

  1. Make central air discharge in the conditions of a specialized workshop.
  2. On petrol engines of 1.6 l of SOHC remove an inlet air line from the butterfly valve case (see. Head of the Power supply system and release).
  3. In a back part of an impellent compartment turn out a shtutserny bolt of fastening of the refrigerator line to thermostatic operated broad valve. Screw a bolt and take the valve. Remove a sealing element. At once stick with an adhesive tape, or закупорьте openings in order to avoid hit in dirt system.

At installation of the valve it is necessary to insert two directing cores, - specialists of car-care center for the purpose of prevention of risk of damage of a tube usually use for a connection press fitting in the valve the Opel KM-6012 adaptation.

  1. Remove a ware box and the bottom sections of furnish of the dashboard (see. Head Body).
  2. Remove the heater fan (see. Removal and installation of the driving electromotor of the fan of a heater).
  1. Remove the salonny filter (see. Head Routine maintenance), then, - at the corresponding complete set, - disconnect electroconducting from the sensor of heating of glass.
  1. Turn out fixing screws and uncover the evaporator, - pay attention that the cover is planted on hermetic, all to which trace should be carefully removed from interfaced surfaces.

On some models for removal of a cover of the evaporator it is necessary to use a knife.

  1. At the corresponding complete set remove the sensor of heating of glass, - try to remember its adjusting situation. Accurately take the evaporator from the heater case.

Zafira models

Some models are equipped with also back evaporator established behind a back quarter of the protective panel.


 PERFORMANCE ORDER

  1. Make central air discharge in the conditions of a specialized workshop.
  1. In a back part of an impellent compartment turn out a shtutserny bolt of fastening of the refrigerator line to thermostatic operated broad valve. Screw a bolt and take the valve. Remove a sealing element. At once stick with an adhesive tape, or закупорьте openings in order to avoid hit in dirt system.

At installation of the valve it is necessary to insert two directing cores, - specialists of car-care center for the purpose of prevention of risk of damage of a tube usually use for a connection press fitting in the valve the Opel KM-6012 adaptation.

  1. Turn out bolts of fastening of a cover of the salonny filter and the evaporator, at the corresponding complete set, disconnect electroconducting from the sensor of heating of glass.
  1. Remove the filter.
  1. At the corresponding complete set remove the sensor of heating of glass, - try to remember its adjusting situation. Accurately take the evaporator from the heater case.

Installation

Installation is made as it should be, the return to an order of dismantle of components. The charging of central air should be made in the conditions of the car-care center workshop which experts will establish as well the broad valve.

For installation of a cover of the evaporator special hermetic is required, - consult at specialists of firm car repair shop Opel.