Opel Astra, Zafira

since 1998 of release

Repair and car operation



Opel Astra
+ Opel Astra and Zafira Cars
+ Operation manual
+ Routine maintenance
+ Engine
- Systems of cooling, heating
   Specifications
   Antifreeze - general information
   + System of cooling of the engine
   - Systems of ventilation, salon and air conditioning heating
      Removal and installation of deflectors of air lines
      Removal and installation of resistive assembly of the driving electromotor of the fan of a heater
      Removal and installation of the driving electromotor of the fan of a heater
      Removal and control panel installation by functioning of systems of heating / ventilation / air conditioning
      Removal and installation of the main case of a heater
      Removal and installation of the heat exchanger of a heater
      Removal and installation of the switch of a heater
      Check of serviceability of functioning and service of systems of heating and air conditioning
      Removal and installation of the compressor of central air of air
      Removal and installation of the evaporator of central air of air
      Removal and installation of the condenser of central air of air
      Removal and installation of a receiver dehumidifier of central air of air
      Removal and installation of the additional fan
+ Power supply system and release
+ engine Electric equipment
+ Manual transmission
+ Automatic transmission
+ Coupling and power shafts
+ Brake system
+ Suspension bracket and steering
+ Body
+ Onboard electric equipment




Removal and installation of the additional fan

 PERFORMANCE ORDER

  1. Remove a front bumper (see. Head Body).
  2. Disconnect from the additional fan electroconducting.
  3. Release fixture and remove assembly of the additional fan, having lowered it down.
  4. In case of need release clamps and remove a plastic lattice, disconnect electroconducting and remove the preliminary resistor. Turn out three fixing bolts and remove a krylchatka from an electromotor shaft. Give fixture and remove the electromotor.

Installation is made upside-down.