Opel Astra, Zafira

since 1998 of release

Repair and car operation



Opel Astra
+ Opel Astra and Zafira Cars
+ Operation manual
+ Routine maintenance
+ Engine
- Systems of cooling, heating
   Specifications
   Antifreeze - general information
   + System of cooling of the engine
   - Systems of ventilation, salon and air conditioning heating
      Removal and installation of deflectors of air lines
      Removal and installation of resistive assembly of the driving electromotor of the fan of a heater
      Removal and installation of the driving electromotor of the fan of a heater
      Removal and control panel installation by functioning of systems of heating / ventilation / air conditioning
      Removal and installation of the main case of a heater
      Removal and installation of the heat exchanger of a heater
      Removal and installation of the switch of a heater
      Check of serviceability of functioning and service of systems of heating and air conditioning
      Removal and installation of the compressor of central air of air
      Removal and installation of the evaporator of central air of air
      Removal and installation of the condenser of central air of air
      Removal and installation of a receiver dehumidifier of central air of air
      Removal and installation of the additional fan
+ Power supply system and release
+ engine Electric equipment
+ Manual transmission
+ Automatic transmission
+ Coupling and power shafts
+ Brake system
+ Suspension bracket and steering
+ Body
+ Onboard electric equipment

http://flashlottos24.ru/


Removal and installation of resistive assembly of the driving electromotor of the fan of a heater

 PERFORMANCE ORDER

  1. Remove a ware box (see. Head Body).
  2. Remove the bottom section of furnish of the dashboard from the passenger, then if it is required, release a clamp and remove a heater air line.
  3. Uncover and take a working element of the salonny filter, - covers of two types are applied, in one of which sealing of landing of a cover is provided with hermetic means. Alternatively remove the driving electromotor of the fan of a heater (see. Removal and installation of the driving electromotor of the fan of a heater).
  1. Accurately вытолкните resistive assembly up, disconnect electroconducting and take the resistor from the case.

    A — Location of resistive assembly of the fan of a heater (execution And)
    B — Location of resistive assembly of the fan of a heater (execution In)

A.

B.

Installation is made upside-down. On as appropriate equipped models do not forget to put hermetic on a cover of the salonny filter.