Opel Astra, Zafira

since 1998 of release

Repair and car operation



Opel Astra
+ Opel Astra and Zafira Cars
+ Operation manual
+ Routine maintenance
+ Engine
- Systems of cooling, heating
   Specifications
   Antifreeze - general information
   + System of cooling of the engine
   - Systems of ventilation, salon and air conditioning heating
      Removal and installation of deflectors of air lines
      Removal and installation of resistive assembly of the driving electromotor of the fan of a heater
      Removal and installation of the driving electromotor of the fan of a heater
      Removal and control panel installation by functioning of systems of heating / ventilation / air conditioning
      Removal and installation of the main case of a heater
      Removal and installation of the heat exchanger of a heater
      Removal and installation of the switch of a heater
      Check of serviceability of functioning and service of systems of heating and air conditioning
      Removal and installation of the compressor of central air of air
      Removal and installation of the evaporator of central air of air
      Removal and installation of the condenser of central air of air
      Removal and installation of a receiver dehumidifier of central air of air
      Removal and installation of the additional fan
+ Power supply system and release
+ engine Electric equipment
+ Manual transmission
+ Automatic transmission
+ Coupling and power shafts
+ Brake system
+ Suspension bracket and steering
+ Body
+ Onboard electric equipment

http://flashlottos24.ru/


Removal and installation of the driving electromotor of the fan of a heater

Removal

Delphi electromotor

 PERFORMANCE ORDER

  1. Remove a ware box (see. Head Body).
  2. Remove the bottom section of furnish of the dashboard from the passenger, then if it is required, release a clamp and remove a heater air line.
  1. Remove the bottom protective panel from the obverse panel from the passenger. Release a clamp and remove an air line from the heater case.
  1. Temporarily include ignition and choose a mode of the closed air circulation (see. Operation manual). Switch off ignition, then disconnect electroconducting and driving draft from the servomotor of a zaslonka of a choice of modes of circulation.
  1. Turn out fixing screws.
  1. Cнимите servomotor.

New servomotors are established at plant in the provision of the closed circulation.

  1. Disconnect electroconducting from the driving electromotor of the fan of a heater.
  1. Turn out three fixing bolts, release clamps and take the electromotor from the case.

    A — Bolts of fastening of a cover of the case of the fan of a heater (execution And)
    B — Bolts of fastening of a cover of the case of the fan of a heater (execution In)

A.

B.

Behr electromotor

 PERFORMANCE ORDER

  1. Temporarily include ignition and choose a mode of the closed air circulation (see. Operation manual). Switch off ignition, then disconnect electroconducting and driving draft from the servomotor of a zaslonka of a choice of modes of circulation, turn out fixing screws and remove the servomotor.

New servomotors are established at plant in the provision of the closed circulation.

  1. Turn out five fixing bolts and release a clamp. Take the electromotor from the case of ventilyatorny assembly, - pay attention that hermetic keeps within a flute of the case, - carefully clean a flute.

Installation

Installation is made upside-down.

 PERFORMANCE ORDER

  1. At installation of the Behr motor do not forget to fill with hermetic a reception flute on the assembly case. Track, that the main gear wheel of the servomotor correctly entered into gearing with the main gear wheel of a zaslonka.