Opel Astra, Zafira

since 1998 of release

Repair and car operation



Opel Astra
+ Opel Astra and Zafira Cars
+ Operation manual
+ Routine maintenance
+ Engine
- Systems of cooling, heating
   Specifications
   Antifreeze - general information
   + System of cooling of the engine
   - Systems of ventilation, salon and air conditioning heating
      Removal and installation of deflectors of air lines
      Removal and installation of resistive assembly of the driving electromotor of the fan of a heater
      Removal and installation of the driving electromotor of the fan of a heater
      Removal and control panel installation by functioning of systems of heating / ventilation / air conditioning
      Removal and installation of the main case of a heater
      Removal and installation of the heat exchanger of a heater
      Removal and installation of the switch of a heater
      Check of serviceability of functioning and service of systems of heating and air conditioning
      Removal and installation of the compressor of central air of air
      Removal and installation of the evaporator of central air of air
      Removal and installation of the condenser of central air of air
      Removal and installation of a receiver dehumidifier of central air of air
      Removal and installation of the additional fan
+ Power supply system and release
+ engine Electric equipment
+ Manual transmission
+ Automatic transmission
+ Coupling and power shafts
+ Brake system
+ Suspension bracket and steering
+ Body
+ Onboard electric equipment




Removal and control panel installation by functioning of systems of heating / ventilation / air conditioning

Removal

Astra models

Delphi control panel

 PERFORMANCE ORDER

  1. Remove an ashtray and a small ware pocket (see. Head Body).
  2. Remove a radio tape recorder with an assembly box (see. Head Onboard electric equipment). At the corresponding complete set remove the navigation block.
  3. Having accurately hooked a suitable screw-driver, remove a decorative facing slip from the dashboard.
  4. Disconnect handles and squeeze out of a facing overlay of a lattice of deflectors. Remove assembly of the multipurpose display (see. Head Onboard electric equipment).
  5. Transfer the handle of a choice of a temperature mode to vertical situation and disconnect a management cable, - try to remember the adjusting provision of a cable.
  6. Disconnect electroconducting from switches of management of functioning of the heater / conditioner of air.
  7. Disconnect the remained cables of management (try to remember an order of their connection) and remove the control panel from a facing slip.

Behr control panel

 PERFORMANCE ORDER

  1. Remove a ware box (see. Head Body).
  2. Remove the bottom finishing sections from both parties of the dashboard.
  3. Remove an air line from the passenger.
  4. Remove the dashboard (see. Head Body).
  5. Disconnect management cables from top and bottom distributive a zaslonok. Liberate cables from intermediate clamps.
  6. Remove an ashtray and a small ware pocket (see. Head Body).
  7. Remove a radio tape recorder with an assembly box (see. Head Onboard electric equipment). At the corresponding complete set remove the navigation block.
  8. Having accurately hooked a suitable screw-driver, remove a decorative facing slip from the dashboard.
  9. Disconnect from the control panel electroconducting and driving cables, - try to remember the adjusting provision of components.
  10. Remove the control panel.

Zafira models


Cables of management of functioning of systems of heating / ventilation / air conditioning (execution And)

  • At a cable detachment with a clamp of gray color the corresponding handle should be established in the situation "Cold"
  • At a cable detachment with a clamp of white color the corresponding handle should be established in situation «Having blown in a windscreen»
  • At a cable detachment with a clamp of green color the corresponding handle should be established in situation «Supply of air in foot wells»

  • Cables of management of functioning of systems of heating / ventilation / air conditioning (execution In)

  • At a cable detachment with a clamp of gray color the corresponding handle should be established in the situation "Cold"
  • At a cable detachment with a clamp of white color the corresponding handle should be established in situation «Having blown in a windscreen»
  • At a cable detachment with a clamp of black color the corresponding handle should be established in situation «Supply of air in foot wells»

  •  PERFORMANCE ORDER

    1. Remove a ware box (see. Head Body).
    2. Remove the bottom finishing sections from both parties of the dashboard.
    3. Remove a forward ashtray.
    1. Turn out the bottom screws and liberate from clamps the top part of the control panel. Liberate the control panel from the dashboard.
    1. By means of a screw-driver accurately liberate the switch of the alarm system, the switch of antiprobuksovochny system (at the corresponding complete set) and the switch of heating of seats (at the corresponding complete set).
    1. Disconnect control panels electroconducting.
    1. Release clamps, disconnect operating drafts and remove the control panel. Try to remember an order of connection of driving cables (see illustrations Cables of management of functioning of systems of heating / ventilation / air conditioning (execution And) and Cables of management of functioning of systems of heating / ventilation / air conditioning (execution In)).

    Installation

    Installation is made upside-down.

     PERFORMANCE ORDER

    1. Track correctness of connection of electroconducting and management cables. Make sure that all control lamps are on the places. At installation of the Delphi panel pay attention to installation of a driving cable of management by functioning of a mixing zaslonka, - the handle of management should not come off back in extreme provisions.