Opel Astra, Zafira

since 1998 of release

Repair and car operation



Opel Astra
+ Opel Astra and Zafira Cars
+ Operation manual
+ Routine maintenance
+ Engine
- Systems of cooling, heating
   Specifications
   Antifreeze - general information
   + System of cooling of the engine
   - Systems of ventilation, salon and air conditioning heating
      Removal and installation of deflectors of air lines
      Removal and installation of resistive assembly of the driving electromotor of the fan of a heater
      Removal and installation of the driving electromotor of the fan of a heater
      Removal and control panel installation by functioning of systems of heating / ventilation / air conditioning
      Removal and installation of the main case of a heater
      Removal and installation of the heat exchanger of a heater
      Removal and installation of the switch of a heater
      Check of serviceability of functioning and service of systems of heating and air conditioning
      Removal and installation of the compressor of central air of air
      Removal and installation of the evaporator of central air of air
      Removal and installation of the condenser of central air of air
      Removal and installation of a receiver dehumidifier of central air of air
      Removal and installation of the additional fan
+ Power supply system and release
+ engine Electric equipment
+ Manual transmission
+ Automatic transmission
+ Coupling and power shafts
+ Brake system
+ Suspension bracket and steering
+ Body
+ Onboard electric equipment

http://flashlottos24.ru/


Removal and installation of the main case of a heater

On the models equipped To/in it is necessary to make previously central air discharge in the conditions of a specialized repair truck.


Brought to the heater case management cables (execution And)

  1. Clamp of a cable of a drive of a mixing zaslonka
  2. Clamp of a cable of a drive of a distributive zaslonka (supply of air on the bottom level)
  3. Clamp of a cable of a drive of a distributive zaslonka (supply of air on the top level)


Brought to the heater case management cables (execution In)

  1. Clamp of a cable of a drive of a distributive zaslonka (supply of air on the top level)
  2. Clamp of a cable of a drive of a mixing zaslonka

Removal

 PERFORMANCE ORDER

  1. Remove the central console and the dashboard (see. Head Body).
  2. Disconnect from the main case of a heater a sleeve of supply of air in back foot wells, - prepare rags for collecting the cooling liquid following from the heat exchanger of a heater.
  3. Remove a passenger safety cushion (see. Head Onboard electric equipment).
  4. Open both lobbies of a door, turn out bolts with heads of the TORX type and remove a steering cross-piece from a partition of an impellent compartment.
  1. On equipped In models cock the parking brake, поддомкратьте a front of the car and establish it on props, at the corresponding complete set remove protection of a case. Remove a back support of the engine (see. Head Engine).


  1. Turn out two fixing bolts and remove from the floor panel intended for removal of condensate drainage knot.


Dismantle of drainage knot is possible and without preliminary removal of a support, however work thus essentially becomes complicated.

  1. Empty cooling system (see. Head Routine maintenance).
  2. Remove from a windscreen a plastic insert, turn out fixing bolts and remove the bottom covering panel.
  1. In an impellent compartment disconnect heater hoses from heat exchanger branch pipes, - previously mark hoses for the purpose of a guarantee of correctness of their connection at assembly.

Firm hoses are equipped with sockets of fast joining.

  1. On equipped In models turn out a shtutserny bolt of the socket of a refrigerator tube on the broad valve.
  2. Take away cases of air distributors from the top part of a partition of an impellent compartment.
  1. On equipped In models disconnect electroconducting from the valve of an otsechka of cooling liquid.
  1. In salon of the car disconnect electroconducting from the servomotor of a circulating zaslonka and from the electromotor of the fan of a heater. Disconnect management cables from the heater case (the Clamp of a cable of a drive of a distributive zaslonka (supply of air on the top level is shown), execution In) (see also illustrations Brought to the heater case management cables (execution And) and Brought to the heater case management cables (execution In)).
  1. Together with the assistant liberate the main case of a heater from a partition of an impellent compartment and take it from salon.

Installation

Installation is made as it should be, the return to an order of dismantle of components.

In summary make filling of system of cooling (see. Head Routine maintenance). At the corresponding complete set drive away the car in a specialized workshop for central air recharge. At installation of a steering cross-piece before a tightening of bolts make sure that the top directing were established on the regular places.