Opel Astra, Zafira

since 1998 of release

Repair and car operation



Opel Astra
+ Opel Astra and Zafira Cars
+ Operation manual
+ Routine maintenance
+ Engine
+ Systems of cooling, heating
+ Power supply system and release
- Engine electric equipment
   Specifications
   - Electronic control system of ignition (and injection) petrol engines
      Checks of serviceability of functioning of system of ignition
      Diagnostics of malfunctions - the general information and preliminary checks
      System of onboard self-diagnostics of OBD - the general information
      Oscillograph application for supervision of workers of a control system
      Removal and installation of the module of ignition
      Check and installation of a corner of an advancing of ignition
      Removal and installation of the switch of ignition
      Removal and installation of the sensor of emergency pressure of oil
      Removal and installation of the sensor of level of impellent oil
      Removal and installation of the sensor of temperature of impellent oil (diesel models)
   + Systems of preheat and heating of fuel of the diesel engine
   + charge and start Systems
+ Manual transmission
+ Automatic transmission
+ Coupling and power shafts
+ Brake system
+ Suspension bracket and steering
+ Body
+ Onboard electric equipment




Removal and installation of the sensor of emergency pressure of oil

Removal

Petrol models and diesel models of 1.7 l of SOHC

The sensor will screw in a back part of the case of the oil pump.

 PERFORMANCE ORDER

  1. At the corresponding complete set turn out fixing bolts and remove protection of a case.
  2. Disconnect from the sensor electroconducting.
  1. Turn out the sensor, - prepare for collecting spilled fuel. If the sensor acts in film for a long time, закупорьте an opening under its installation by a suitable cap.

    1 — the Contact socket of electroconducting
    2 — the Sensor

Diesel models of 1.7 l of DOHC

 PERFORMANCE ORDER

  1. The sensor will screw in the left part of the block of cylinders, below and slightly behind the thermostat case, - for the purpose of ensuring adequate access, remove the storage battery with the adjusting pallet (see. Check of serviceability of functioning of system of preheat).
  1. Disconnect electroconducting and turn out the sensor, - prepare for collecting spilled fuel. If the sensor acts in film for a long time, закупорьте an opening under its installation by a suitable cap.

Diesel models of 2.0 l

 PERFORMANCE ORDER

  1. At the corresponding complete set remove protection of a case.
  2. The sensor will screw in a back part of the block of cylinders, over a power shaft, - disconnect from it electroconducting.
  1. Turn out the sensor, - prepare for collecting spilled fuel. If the sensor acts in film for a long time, закупорьте an opening under its installation by a suitable cap.

    1 — the Contact socket of electroconducting
    2 — the Sensor

Installation

 PERFORMANCE ORDER

  1. Slightly grease a carving part of the sensor with fixing hermetic.
  2. Screw the sensor on the regular place and tighten it with demanded effort. Attach electroconducting.
  3. On petrol models and diesel models of 1.7 l of SOHC and 2.0 l establish protection of a case.
  4. On engines of 1.7 l of DOHC establish the storage battery with the pallet (see. Check of serviceability of functioning of system of preheat).
  5. Check oil level in the engine, in case of need make the corresponding adjustment (see. Head Routine maintenance).