Opel Astra, Zafira

since 1998 of release

Repair and car operation



Opel Astra
+ Opel Astra and Zafira Cars
+ Operation manual
+ Routine maintenance
+ Engine
+ Systems of cooling, heating
+ Power supply system and release
- Engine electric equipment
   Specifications
   - Electronic control system of ignition (and injection) petrol engines
      Checks of serviceability of functioning of system of ignition
      Diagnostics of malfunctions - the general information and preliminary checks
      System of onboard self-diagnostics of OBD - the general information
      Oscillograph application for supervision of workers of a control system
      Removal and installation of the module of ignition
      Check and installation of a corner of an advancing of ignition
      Removal and installation of the switch of ignition
      Removal and installation of the sensor of emergency pressure of oil
      Removal and installation of the sensor of level of impellent oil
      Removal and installation of the sensor of temperature of impellent oil (diesel models)
   + Systems of preheat and heating of fuel of the diesel engine
   + charge and start Systems
+ Manual transmission
+ Automatic transmission
+ Coupling and power shafts
+ Brake system
+ Suspension bracket and steering
+ Body
+ Onboard electric equipment




Removal and installation of the sensor of level of impellent oil

Petrol models

L models 1.4, 1.6 and 1.8

The sensor of level of oil is established in the pallet of a case of the engine, from its forward party.

 PERFORMANCE ORDER

  1. Cock the parking brake, поддомкратьте a front of the car and establish it on props. At the corresponding complete set remove protection of a case of the engine.
  2. Merge impellent oil in pure capacity, screw into place a drain stopper and tighten it with demanded effort (see. Head Routine maintenance).
  3. Disconnect from the sensor electroconducting.
  1. Turn out fixing bolts and remove the sensor assembled with a sealing ring, - the ring is subject to replacement without fail.
  1. Installation is made upside-down. Track correctness of laying of electroconducting. In summary fill in in the engine oil (see. Head Routine maintenance).

Models of 2.0 l

The sensor (if it is provided) is established in the pallet of a case of the engine.

 PERFORMANCE ORDER

  1. Remove the bottom section of the pallet (see. Head Engine).
  2. Turn out fixing bolts and remove the sensor, - try to remember a route of laying of electroconducting. Check a condition of a sealing element, - in case of need make its replacement.
  3. Before installation carefully clean a carving of fixing bolts, having completely removed them it all traces of old hermetic. Put fresh hermetic. Grease a sealing element with impellent oil.
  4. Establish the sensor (track correctness of laying of electroconducting) and tighten bolts of its fastening with demanded effort. Pass the contact socket via the pallet, - try not to damage a sealing element. Latch a lock clamp.
  5. Make sure of correctness of landing of the sensor, then establish into place the bottom section of the pallet (see. Head Engine).

Diesel models

The sensor of level of oil (if it is established) is established in the pallet.

 PERFORMANCE ORDER

  1. Remove the pallet (see. Head Engine).
  2. Remove a lock ring and push the contact socket of electroconducting of the sensor in the pallet.
  3. Turn out fixing bolts and remove the sensor.
  4. Establish the sensor on the regular place, screw and tighten with demanded effort fixing bolts.
  1. Establish a new sealing ring, plant the electroconducting socket in an opening in the pallet and fix it a lock ring (1).
  1. Establish the pallet (see. Head Engine).