Opel Astra, Zafira

since 1998 of release

Repair and car operation



Opel Astra
+ Opel Astra and Zafira Cars
+ Operation manual
+ Routine maintenance
+ Engine
+ Systems of cooling, heating
+ Power supply system and release
+ engine Electric equipment
+ Manual transmission
- Automatic transmission
   Specifications
   Adjustment of the mechanism of a choice of transfers
   Removal and installation of a cable of a choice of transfers
   Removal and installation of assembly of the lever of the AT selector
   Replacement of epiploons
   ATF cooler - the general information
   Removal and installation of electric components of a control system of AT
   Removal and AT installation
   Major maintenance of AT - the general information
+ Coupling and power shafts
+ Brake system
+ Suspension bracket and steering
+ Body
+ Onboard electric equipment




Removal and installation of a cable of a choice of transfers

Removal

 PERFORMANCE ORDER

  1. Remove the central console (see. Head Body). Transfer the selector lever to the situation "R".
  1. Screw-driver with a flat sting release a clamp and accurately liberate a cable tip from a basic arm, then disconnect a cable from a fixing plate in a forward part of the executive lever.
  1. Remove the storage battery with the adjusting pallet (see. Head engine Electric equipment).
  2. At the corresponding complete set release a clamp and accurately separate a cable tip from the AT selector lever. Liberate a cable cover from a basic arm.
  3. Walk on all length of a cable from transmission and liberate it from all provided intermediate clamps, do not take the rubber plug through passage from a partition of an impellent compartment.
  4. Check a cable condition — the cable should move freely in a cover.

The cable removed from the car can look and function quite regularly, however to start to jam when bending. In case of need replace a cable.

Installation

 PERFORMANCE ORDER

  1. Get a cable on the regular place, having passed it in the plug through passage in a partition of an impellent compartment. Fix a cable in a lever plate.

For simplification of dragging of a cable through the plug through passage previously grease it with soap solution.

  1. Pass the end which was moved to transmission of a cable in a basic arm and fix a cover a clamp. Connect a cable tip to the lever and (at the corresponding complete set) fix it a clamp.
  2. In salon of the car fix a cable cover a clamp and connect a tip to the hinge of the lever of the selector.
  3. Adjust length of a cable (see. Adjustment of the mechanism of a choice of transfers).
  4. Establish the central console and other acting in film components.