Opel Astra, Zafira

since 1998 of release

Repair and car operation



Opel Astra
+ Opel Astra and Zafira Cars
+ Operation manual
+ Routine maintenance
+ Engine
+ Systems of cooling, heating
+ Power supply system and release
+ engine Electric equipment
+ Manual transmission
- Automatic transmission
   Specifications
   Adjustment of the mechanism of a choice of transfers
   Removal and installation of a cable of a choice of transfers
   Removal and installation of assembly of the lever of the AT selector
   Replacement of epiploons
   ATF cooler - the general information
   Removal and installation of electric components of a control system of AT
   Removal and AT installation
   Major maintenance of AT - the general information
+ Coupling and power shafts
+ Brake system
+ Suspension bracket and steering
+ Body
+ Onboard electric equipment




Removal and installation of assembly of the lever of the AT selector

The description of procedure of replacement of switches of modes – see. Removal and installation of electric components of a control system of AT.

Removal

 PERFORMANCE ORDER

  1. Remove the central console (see. Head the Body), then transfer the selector lever to the situation "P".
  2. Disconnect electroconducting from switches of modes and liberate a cartridge of a lamp from the display panel.
  3. Having accurately hooked a screw-driver, separate a cable tip from the lever hinge. Shift a clamp and liberate a cable from a basic arm in front of the lever.
  4. Turn out four fixing screws and remove lever assembly.
  5. Check knot on existence of signs of wear and damages. Give a nut, remove a washer and take axis knot. Release clamps of fastening of the display panel, separate lever knot with a basic arm. More complete dismantling of knot is not represented possible.

Installation

 PERFORMANCE ORDER

  1. In case of need establish on lever assembly a basic arm. Insert an axis. Establish a washer and tighten a fixing nut with demanded effort. Strengthen the display panel on a basic arm. Before lever installation on the car check serviceability of functioning of assembly.
  2. Establish lever knot on the regular place, connect a selector cable. Screw fixing bolts and tighten them with demanded effort.
  3. Fix a selector cable a clamp and connect a cable tip to the lever hinge.
  4. Having tracked correctness of laying of a plait, lay electroconducting, establish a cartridge of Pampas on the display panel and restore initial connection of electroconducting.
  5. Adjust a cable valley (see. Adjustment of the mechanism of a choice of transfers), then establish into place the central console (see. Head Body).