Opel Astra, Zafira

since 1998 of release

Repair and car operation



Opel Astra
+ Opel Astra and Zafira Cars
+ Operation manual
+ Routine maintenance
+ Engine
+ Systems of cooling, heating
+ Power supply system and release
+ engine Electric equipment
- Manual transmission
   Specifications
   Adjustment of a drive of gear shifting
   Removal and installation of the mechanism of gear shifting
   Replacement of epiploons
   Check of serviceability of functioning, removal and installation of the sensor switch of fires of a backing
   Removal and installation of the sensor of speed (VSS)
   Replacement of transmission oil
   Removal and RKPP installation
   RKPP repair - the general information
+ Automatic transmission
+ Coupling and power shafts
+ Brake system
+ Suspension bracket and steering
+ Body
+ Onboard electric equipment




Adjustment of a drive of gear shifting

F13, F17 and F18 models

For performance of this procedure the drill or a drift in diameter of 5 mm is required.

Adjustment of a drive of switching is not among routine procedures of routine maintenance of the car and need for its carrying out arises after removal of the mechanism of switching. At violation of clearness of gear shifting serviceability of functioning of a drive can be checked, the corresponding adjustments are in case of need made.

Adjustment is carried out by means of a bolt of a collar of fastening of a rod of a choice of transfers to draft of switching (see. Removal and installation of the mechanism of gear shifting). The bolt is under the power unit, directly ahead of a back partition of an impellent compartment. On the majority of models access to the screw is possible from above, otherwise follows поддомкратить a front of the car and to establish it on props, - access to a bolt from below is strongly limited.

 PERFORMANCE ORDER

  1. Weaken (but do not give completely) a bolt of a fixing collar of a rod of a choice of transfers.
  1. In salon of the car liberate from clamps and wrap up a protective cover of the lever of gear shifting. Fix the lever by means of a drill / drift in diameter of 5 mm, passed in a collar at the left on the bases of the lever and filled in a special fixing opening.
  1. Having established the switching mechanism in the provision of neutral transfer, turn a selector shaft, overcoming resistance of a spring, and block the mechanism in this situation, having drowned a podpruzhinenny lock pin in the transmission located from above on a case to a cover.
  1. Make sure of reliability of blocking of the lever and the switching mechanism, tighten a bolt of a collar of a rod of a choice of transfers with effort of a stage 1, then hold on it on a corner of a stage 2 (see. Specifications).
  1. Remove from the gear shifting lever fixing its drill / drift and check operation of the mechanism of switching, - the podpruzhinenny lock pin will automatically be liberated at transfer of the lever to the provision of a reverse gear.
  2. Make sure that the lock pin jumped out of a cover, then (if lifted) lower the car on the earth.

F23 models

 PERFORMANCE ORDER

  1. Uncover the central console and a cover of the lever of switching (see. Head Body).
  1. Accurately hooking a small screw-driver, release both latches of driving cables.
  1. In an impellent compartment transfer the choice lever to the provision of neutral transfer and block it in this situation, having drowned a clamp.
  1. Having wrung out back, block clamps of both cables.
  1. Extend a collar of fastening of the lever and establish into place a cover of the lever and a cover of the central console (see. Head the Body), then check serviceability of functioning of the mechanism of switching.