Opel Astra, Zafira

since 1998 of release

Repair and car operation



Opel Astra
+ Opel Astra and Zafira Cars
+ Operation manual
+ Routine maintenance
+ Engine
+ Systems of cooling, heating
+ Power supply system and release
+ engine Electric equipment
+ Manual transmission
+ Automatic transmission
- Coupling and power shafts
   Specifications
   - Coupling
      Coupling - the general information and check of a condition of components
      Removal and installation of the main cylinder of coupling
      Removal and installation of assembly of the executive cylinder of coupling with the vyzhimny bearing
      Air removal from a hydraulic path of a drive of switching off of coupling
      Removal and installation of a pedal of coupling
      Removal, check of a condition and installation of components of coupling
   + Power shafts
+ Brake system
+ Suspension bracket and steering
+ Body
+ Onboard electric equipment


discounts for cialis cheap cialis how much cialis can i take in one day


Removal and installation of assembly of the executive cylinder of coupling with the vyzhimny bearing

Remember that developed in the course of wear of frictional overlays of a conducted disk of coupling the dust can contain unhealthy asbestos. Do not blow off a dust the compressed air and try not to inhale it. Do not apply to rubbing of components of coupling solvents on an oil basis — use only special brake cleaners or pure methyl alcohol. The used rags put in tightly closed container.

Removal

 PERFORMANCE ORDER

  1. For removal of assembly of the executive cylinder with the vyzhimny bearing it is necessary to dismantle a gear shifting box (see. Head the Manual transmission) or to remove the power unit.
  1. Carefully wipe the cylinder outside, then release a nut of the shtutserny socket and disconnect from the cylinder the hydraulic line — at once collect rags traces of the spilled hydraulic liquid.
  2. Turn out three fixing bolts and remove the cylinder from an entrance shaft. Remove the sealing ring established between the cylinder and a case of RKPP — the ring is subject to replacement without fail. Accept precautionary measures against hit in a dirt box.

    Scheme of installation of the executive cylinder of coupling
    1 — the Nut of shtutserny connection of the hydraulic line
    Shooters — Bolts of fastening of the cylinder

  1. Failed executive to regenerative repair is not subject. In case of development of leakages of hydraulic liquid replace the cylinder assembled.

Installation

 PERFORMANCE ORDER

  1. Make sure of absoluteness of purity and dryness of interfaced surfaces of the cylinder and RKPP case. Plant a new sealing ring in a reception flute on a transmission case.
  2. Grease the cylinder with pure transmission oil, plant it on a pin of a shaft and press to RKPP case. Check landing of a sealing ring in a reception flute, then screw fixing bolts and tighten them with demanded effort.
  3. Connect to the cylinder the hydraulic line and tighten a shtutserny nut with demanded effort.
  4. Establish a transmission on the engine (see. Head Manual transmission).
  5. Pump over hydraulic system (see. Air removal from a hydraulic path of a drive of switching off of coupling).