Opel Astra, Zafira

since 1998 of release

Repair and car operation



Opel Astra
+ Opel Astra and Zafira Cars
+ Operation manual
+ Routine maintenance
+ Engine
+ Systems of cooling, heating
- Power supply system and release
   - Power supply system
      Sbrasyvaniye of pressure in a power supply system of petrol engines
      Check of a condition and replacement of fuel lines and their shtutserny connections
      Air removal from a fuel path of the diesel engine
      Removal of pollution from a power supply system of the diesel engine
      Removal and installation of components of an inlet air path
      Removal, installation and adjustment of a cable of gas - petrol models
      Removal and installation of a pedal of an accelerator
      Removal and installation of the fuel pump - petrol models
      Removal and installation of the sensor of a stock of fuel
      Removal and installation of a fuel tank
      Removal and installation of the case of a throttle - petrol models
   + System of injection of fuel of petrol engines
   + Systems of injection and turbo-supercharging of the diesel engine
   + Systems of release and decrease in toxicity of the fulfilled gases
+ engine Electric equipment
+ Manual transmission
+ Automatic transmission
+ Coupling and power shafts
+ Brake system
+ Suspension bracket and steering
+ Body
+ Onboard electric equipment

http://flashlottos24.ru/


Air removal from a fuel path of the diesel engine

Air removal after filling of a path of a power supply system occurs automatically, than and lack of gates of pumping speaks.

 PERFORMANCE ORDER

  1. Start the engine (procedure can take a little more time, than usually, especially, if fuel from system was completely merged — turn a cranked shaft a starter not more long 10 seconds, in case of need repeat attempt, having waited for not less than 30 seconds) and let's to it work few minutes on fast single turns. After air jams will be completely removed from a power supply system path, stability of turns of idling should be restored.
  2. Insufficient stability of functioning of the engine testifies what not all air left a path — for few minutes lift engine turns, then again dump them to the single. Continue pumping until demanded stability of single turns will be reached.