Opel Astra, Zafira

since 1998 of release

Repair and car operation



Opel Astra
+ Opel Astra and Zafira Cars
+ Operation manual
+ Routine maintenance
+ Engine
+ Systems of cooling, heating
- Power supply system and release
   - Power supply system
      Sbrasyvaniye of pressure in a power supply system of petrol engines
      Check of a condition and replacement of fuel lines and their shtutserny connections
      Air removal from a fuel path of the diesel engine
      Removal of pollution from a power supply system of the diesel engine
      Removal and installation of components of an inlet air path
      Removal, installation and adjustment of a cable of gas - petrol models
      Removal and installation of a pedal of an accelerator
      Removal and installation of the fuel pump - petrol models
      Removal and installation of the sensor of a stock of fuel
      Removal and installation of a fuel tank
      Removal and installation of the case of a throttle - petrol models
   + System of injection of fuel of petrol engines
   + Systems of injection and turbo-supercharging of the diesel engine
   + Systems of release and decrease in toxicity of the fulfilled gases
+ engine Electric equipment
+ Manual transmission
+ Automatic transmission
+ Coupling and power shafts
+ Brake system
+ Suspension bracket and steering
+ Body
+ Onboard electric equipment




Removal and installation of a pedal of an accelerator

Petrol models

 PERFORMANCE ORDER

  1. In car salon, for the purpose of ensuring access to pedal assembly, release fixture and remove the left (driver's) bottom section of furnish of the dashboard.
  2. Liberate a tip of a cable of gas from an accelerator pedal.
  1. Give three fixing nuts and remove pedal assembly from a partition of an impellent compartment.
  1. Check components of pedal assembly on existence of signs of wear and mechanical damages, replace the failed elements. For dismantling of pedal knot, unhook a spring, shift a clamp and remove a pedal, a basic arm, a returnable spring and axial plugs, - before installation grease plugs and a pedal axis with universal greasing.
  2. Establish on an arm of the plug and a returnable spring, having passed through a spring, establish a pedal. Fix a pedal a clamp and pick up to it a spring.
  3. Establish pedal assembly on a regular place and tighten fixing nuts with demanded effort.
  4. Connect to a pedal a gas cable, check reliability of landing of the plug through passage, then establish into place finishing section of the dashboard.
  5. In summary make adjustment of a cable of gas (see. Removal, installation and adjustment of a cable of gas - petrol models).

Diesel models

 PERFORMANCE ORDER

  1. In car salon, for the purpose of ensuring access to pedal assembly, release fixture and remove the left (driver's) bottom section of furnish of the dashboard.
  1. Give fixing nuts and remove pedal assembly from a partition of an impellent compartment.
  1. Having shifted a locking element on the socket, disconnect electroconducting from the sensor of provision of a pedal of an accelerator.
  2. At the moment of drawing up of the real Management the pedal knot was made by not folding. In case of a pedal exit out of operation the knot is subject to replacement assembled.
  3. Establish pedal assembly and tighten nuts of its fastening with demanded effort.
  4. Connect electroconducting to the sensor of provision of a pedal and establish into place the bottom section of furnish of the dashboard.