Opel Astra, Zafira

since 1998 of release

Repair and car operation



Opel Astra
+ Opel Astra and Zafira Cars
+ Operation manual
+ Routine maintenance
+ Engine
+ Systems of cooling, heating
+ Power supply system and release
+ engine Electric equipment
+ Manual transmission
+ Automatic transmission
+ Coupling and power shafts
+ Brake system
- Suspension bracket and steering
   Specifications
   Removal and installation of a rotary fist
   Check of a condition and replacement of stupichny assembly
   Removal and installation of a forward stretcher
   Removal, regenerative repair and installation of a rack of a forward suspension bracket
   Removal and installation of the forward stabilizer of cross-section stability
   Removal, regenerative repair and installation of the bottom lever of a forward suspension bracket
   Replacement of the bottom spherical support
   Removal and installation of back stupichny assembly
   Check of a condition and replacement of bearings of back wheels
   Removal, check of a condition and installation of the back shock-absorber
   Removal and installation of screw springs of a back suspension bracket
   Removal and installation of a torsionny beam of a back suspension bracket
   Replacement of rezinometallichesky hinges of longitudinal levers of a torsionny beam
   System of adjustment of a road gleam of a back axis - the general information and adjustment
   Removal and installation of the air valve and highway of a regulator of a road gleam of a back axis (Versatile person model)
   Removal and installation of a steering wheel
   Removal and installation of a steering column
   Removal, check of a condition and installation of an intermediate shaft of a steering column
   Replacement of protective covers of a case of the steering mechanism
   Removal and installation of the steering mechanism
   Removal and installation of the steering pump
   Air removal from a hydraulic path of GUR
   Removal and installation of tips of steering drafts
   Removal and installation of steering draft
   Corners of installation of wheels
+ Body
+ Onboard electric equipment

http://flashlottos24.ru/


System of adjustment of a road gleam of a back axis - the general information and adjustment

General information

This system is established on the Versatile person models and provides possibility of adjustment of size of a road gleam of a back axis of the car depending on extent of its loading. Adjustment is made by adjustment of pressure of air in back shock-absorbers by means of the operated valve established on the right in a luggage compartment.

For safety reasons air should not be in a working path of system under the maximum pressure if the car is not loaded completely.

Adjustment

 PERFORMANCE ORDER

  1. Unload the car and measure pressure in system by a tire manometer. Nominal pressure makes 0.8 bar. In case of need make the corresponding adjustment.

Pressure in system never should fall below value 0.8 bar!

  1. Park the car on an equal horizontal surface, it is desirable with a firm covering and measure distance of I from the upper edge of a rear bumper to the earth. Subtract from the received value of 50.0 mm and write down result.
  2. Lay in the car the prepared luggage if it is required, correct pressure in system, achieving demanded value of the measurement described in the previous paragraph.

Do not lift pressure in a path of system over 5.0 bar!

  1. After unloading of the car do not forget to dump pressure to nominal level (0.8 bar).