Opel Astra, Zafira

since 1998 of release

Repair and car operation



Opel Astra
+ Opel Astra and Zafira Cars
+ Operation manual
+ Routine maintenance
+ Engine
+ Systems of cooling, heating
+ Power supply system and release
+ engine Electric equipment
+ Manual transmission
+ Automatic transmission
+ Coupling and power shafts
+ Brake system
- Suspension bracket and steering
   Specifications
   Removal and installation of a rotary fist
   Check of a condition and replacement of stupichny assembly
   Removal and installation of a forward stretcher
   Removal, regenerative repair and installation of a rack of a forward suspension bracket
   Removal and installation of the forward stabilizer of cross-section stability
   Removal, regenerative repair and installation of the bottom lever of a forward suspension bracket
   Replacement of the bottom spherical support
   Removal and installation of back stupichny assembly
   Check of a condition and replacement of bearings of back wheels
   Removal, check of a condition and installation of the back shock-absorber
   Removal and installation of screw springs of a back suspension bracket
   Removal and installation of a torsionny beam of a back suspension bracket
   Replacement of rezinometallichesky hinges of longitudinal levers of a torsionny beam
   System of adjustment of a road gleam of a back axis - the general information and adjustment
   Removal and installation of the air valve and highway of a regulator of a road gleam of a back axis (Versatile person model)
   Removal and installation of a steering wheel
   Removal and installation of a steering column
   Removal, check of a condition and installation of an intermediate shaft of a steering column
   Replacement of protective covers of a case of the steering mechanism
   Removal and installation of the steering mechanism
   Removal and installation of the steering pump
   Air removal from a hydraulic path of GUR
   Removal and installation of tips of steering drafts
   Removal and installation of steering draft
   Corners of installation of wheels
+ Body
+ Onboard electric equipment

http://flashlottos24.ru/


Removal and installation of the forward stabilizer of cross-section stability

Originators of the real Management recommend to make replacement of all carving fixture without fail.

Removal

 PERFORMANCE ORDER

  1. Remove a forward stretcher (see. Removal and installation of a forward stretcher).
  1. Mark adjusting position of vertical drafts of the stabilizer. Release fixing nuts and disconnect drafts from a stabilizer bar, - at an otpuskaniye of nuts hold a sharnirny finger of draft from a provorachivaniye the second key for specially provided лыски.
  1. Turn out bolts of collars of fastening of a bar of the stabilizer to a stretcher.

The "become attached" bolts can be cut off with the subsequent drilling of the remains, - at assembly it is necessary to use inserts (consult with specialists of car-care center).

  1. Remove a bar of the stabilizer of cross-section stability from a stretcher.
  2. Remove from a stabilizer bar rubber plugs, - try to remember the adjusting provision of components.
  3. Study a condition of a bar of the stabilizer, its vertical drafts and rubber plugs. The worn-out or damaged components replace.

Installation

Installation is made as it should be, the return to an order of dismantle of components. Pay attention to the next moments.

 PERFORMANCE ORDER

  1. Rubber plugs should be established on a stabilizer bar by cutting locks forward.
  2. Track, that all carving fixture was replaced and will tighten with demanded effort.
  3. Installation of a forward stretcher make according to instructions (see. Removal and installation of a forward stretcher).